|November 6, 2016, 01:45||
FSI - negative volume in very elastic walls model
Join Date: Jun 2016
Posts: 12Rep Power: 2
I'm trying to solve a model of a blood flow in very elastic walls using 2-way Fluid-Structure-Interaction and time-depentend velocity. The strains are much greater then the cell size next to the wall, so I've got a problem with dynamic mesh - negative volume. When I use a poor mesh without any inflation, I can solve several time steps without this problem, but after that number of time steps I receive a problem with convergence (continuity). Furthermore, the model with a poor mesh is very inaccurate, obviously.
I'm using a structural, hexahedral mesh. I use dynamic mesh: smoothing and layering.
Can you give me some advices, how can I solve this model with high quality mesh not receiving above problems - negative volume or convergence?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem of simulating of small droplet with radius of 2mm||liguifan||OpenFOAM Running, Solving & CFD||5||June 3, 2014 02:53|
|Negative Volume during Mesh Motion Analysis||giov_ingr||FLUENT||2||December 13, 2013 07:09|
|non-orthogonal faces and incorrect orientation?||nennbs||OpenFOAM Native Meshers: blockMesh||7||April 17, 2013 05:42|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Axisymmetrical mesh||Rasmus Gjesing (Gjesing)||OpenFOAM Native Meshers: blockMesh||10||April 2, 2007 14:00|