|
[Sponsors] |
November 24, 2016, 13:32 |
Ribbed duct meshing
|
#1 |
New Member
PALLABI
Join Date: Nov 2016
Posts: 8
Rep Power: 9 |
Hello everyone, i have a doubt about mesh size. Is is required that the mesh size of both smooth duct and ribbed duct should be same? I have a mesh size with inflation layers 13 for smooth duct. Is it necessary that the inflation layer of ribbed duct should also be 13? I tried, but the meshing fails for ribbed one.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing for rectangular duct | SENER | Mesh Generation & Pre-Processing | 1 | December 11, 2015 07:41 |
Help me to choose between Ansys Meshing, Fluent Meshing or ICEM ? | pipolaki | ANSYS | 0 | December 6, 2013 08:12 |
meshing a duct in gambit | ako | ANSYS Meshing & Geometry | 7 | April 2, 2009 22:07 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |