|December 2, 2016, 06:57||
Checking UDF material properties
Join Date: Oct 2016
Posts: 16Rep Power: 2
Since for my simulation I am using water from sub-to supercritical state
i had to use a UDF (which i kindly was provided with from another Fluent User) to input a table of discrete material properties.
I can compile and then load the library, but i am not sure how i can check if the values are working correctly?
I tried the reference values tab, and compute values from inlet (for which i changed the temperatures) but the other properties don't seem to change.
Is this the correct way to check fluid properties?
Is there another way, to maybe plot e.g. density over temperature?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fluent UDF to interpolate material properties from Temp and Pressure dependent table||lablan||Fluent UDF and Scheme Programming||12||March 20, 2017 18:49|
|checking for C++ compiler default output file name... configure: error: C++ compiler||dhxlxz||SU2 Installation||2||September 7, 2013 11:08|
|[GAMBIT] Problem with interior faces||miro2000||ANSYS Meshing & Geometry||11||August 24, 2013 14:00|
|Material Properties for Sat. Liquid and Sat. Vapor||Blackhawks84||FLUENT||0||September 17, 2012 19:11|
|Constant velocity of the material||Sas||CFX||15||July 13, 2010 08:56|