|
[Sponsors] |
December 8, 2016, 02:35 |
valve seat does -belong to port body
|
#1 |
New Member
Leuven
Join Date: Dec 2016
Posts: 2
Rep Power: 0 |
I have create a valve seat by using ANSYS workbench. In the valve seat selection option, I select the surface of valve seat which will make contact with valve surface. But "valve seat does -belong to port body" error keep coming out. What should I do?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve seat warning problem | soliddesign | FLUENT | 1 | September 2, 2022 04:06 |
"The valve seat does not belong to the port" message | Ad.Al.Qads | FLUENT | 3 | September 1, 2022 14:34 |
udf for valve closing a pipe using dynamic mesh | chem engineer | Fluent UDF and Scheme Programming | 2 | May 13, 2017 09:39 |
select valve seat for a valve in IC Engine | tarun_aseri | FLUENT | 1 | September 12, 2014 23:57 |
[Workbench] Valve seat not aligned with valve face problem | gsr_132 | ANSYS Meshing & Geometry | 0 | June 21, 2014 03:26 |