|
[Sponsors] |
Simulating Flow around a displacement ship hull with trim and sinkage |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 27, 2017, 03:07 |
Simulating Flow around a displacement ship hull with trim and sinkage
|
#1 |
New Member
Anam
Join Date: Sep 2011
Posts: 14
Rep Power: 14 |
Dear All,
I want to simulate the flow around a displacement ship hull with trim and sinkage using Ansys Fluent. In the dynamic mesh settings, i have to enter the the center of gravity location (x, y and z component). In my understanding, the Center of Flotation is "the pivot point about which the boat changes trim" and that this point is located "somewhat abaft the Center of Buoyancy," which itself is "in line vertically with the center of gravity." So should i use the Center of Flotation location instead of center of gravity location? Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free Surface Ship Flow | timfranke | OpenFOAM Running, Solving & CFD | 322 | March 3, 2021 09:04 |
Ship hull with appendage as seperate patch runs into error | manoj_nav | OpenFOAM Running, Solving & CFD | 1 | March 13, 2016 09:12 |
Run time post-processing of trim and sinkage of a hull | manoj_nav | OpenFOAM Post-Processing | 0 | January 11, 2016 04:35 |
Flow around a ship hull with trim and sinkage | manoj_nav | STAR-CCM+ | 9 | July 14, 2015 04:42 |