CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Temperature dependent values in dependence of K?

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 2, 2017, 14:46
Default Temperature dependent values in dependence of K?
  #1
Member
 
Join Date: Nov 2016
Posts: 73
Rep Power: 9
h0rst is on a distinguished road
Hello everyone,

in Fluent, I would like to apply temperature dependent values.

I have a polynominal curve that describes the heat conductance of copper in dependence of temperature. It is attached to this post whereas one curve is in dependence of celsius and one in Kelvin.

I use Celsius as the unit for temperature. In the manual it is stated:

"If you define a polynomial or piecewise-polynomial function of temperature, the temperature
in the function is always in units of Kelvin or Rankine. If you use Celsius or Kelvin as the
temperature unit, then polynomial coefficient values must be entered in terms of Kelvin."


This would mean that I shall use the blue curve (Kelvin curve). Then, the constant coefficient is 408,8 whereas the constant coefficient of the celsius curve is 386,5.

The previous (by Ansys) implemented value was 386,1 which is very close to the value of the red curve. Therefore I'm a bit confused which curve is the right curve to implement.


Best regards
h0rst
Attached Images
File Type: png heat-conductance-copper.png (19.1 KB, 7 views)
h0rst is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
UDF for Temperature Dependent Energy Source er.mkumar Fluent UDF and Scheme Programming 9 March 14, 2024 05:01
Temperature dependent Viscosity using Power-Law shikamaru OpenFOAM Running, Solving & CFD 3 January 6, 2015 02:47
Calculation of the Governing Equations Mihail CFX 7 September 7, 2014 07:27
temperature dependent heat flux rohinibc Fluent UDF and Scheme Programming 0 December 11, 2012 09:45
[swak4Foam] adjust inlet temperature depending on values of monitor points (groovyBC) braennstroem OpenFOAM Community Contributions 2 May 31, 2011 14:45


All times are GMT -4. The time now is 01:40.