|
[Sponsors] |
How to set the grid size of a rectangular cavity? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 1, 2017, 10:35 |
How to set the grid size of a rectangular cavity?
|
#1 |
New Member
Thomas
Join Date: Jan 2017
Posts: 14
Rep Power: 9 |
Hello there,
I am trying to get the same results as in a research paper, where an inclined rectangular cavity was modeled and air was set as a working fluid. The paper mentions a set grid size of 27x27x800. I only know how to set the element size in Meshing. Is there a way to set the grid size? I think the different mesh sizing can be the reason why my results differ from those in the research paper. Thank you, Arttis |
|
March 1, 2017, 15:03 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,654
Rep Power: 65 |
Can't you just take the dimensions and divide by the number of cells in each dimension to get the grid size?
|
|
March 2, 2017, 13:47 |
|
#3 | |
New Member
Thomas
Join Date: Jan 2017
Posts: 14
Rep Power: 9 |
Quote:
ansys question for cfd forum.png |
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
exists minimum grid size for Ansys calculation? | sooh2121 | ANSYS | 2 | March 7, 2012 11:34 |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 05:31 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
grid size | jay | Siemens | 6 | September 5, 2008 06:00 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 11:15 |