setting static pressure as bc
2 Attachment(s)
Hello,
for a university project we need to simulate a manifold (as shown below). The task is to set the static pressure at the two small outlets/inlets so that: 1. p1 = p2 and 2. p2 - p1 = 750mbar. The Problem is that we're only able to set the total pressure and not the static pressure. Can someone help? |
Quote:
|
ANSYS Fluent :)
|
You can actually use a pressure outlet as an inlet. Fluent will complain there is reverse flow, but you can ignore it. It's not allowed because it's usually a non-sensible thing to do (and also practically impossible).
|
All times are GMT -4. The time now is 22:51. |