|
[Sponsors] |
March 11, 2017, 03:57 |
Mesh quality in fluent
|
#1 |
New Member
Luo Song
Join Date: Nov 2016
Posts: 4
Rep Power: 9 |
Hello everyone
I have a mesh quality problem: when I check my mesh quality in ICEM, Determinant2*2*2 is upper than 0.34,angle is upper than 22,but when I check my mesh in fluent,I have this: Minimum Orthogonal Quality = 6.25472e-03 (Orthogonal Quality ranges from 0 to 1, where values close to 0 correspond to low quality.) Warning: minimum Orthogonal Quality below 0.01. Maximum Ortho Skew = 9.93745e-01 (Ortho Skew ranges from 0 to 1, where values close to 1 correspond to low quality.) Why the minimum orthogonal quality doesn't reach the point?How can I change it in ICEM、 |
|
Tags |
mesh quality, warning |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Pointwise Mesh into Fluent - Error: "Divergence detected in AMG solver: ads-0." | kyles.sverige | ANSYS Meshing & Geometry | 3 | January 27, 2015 13:28 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
[Other] Quality Mesh Analysis > relation with convergence | vitorspadetoventurin | OpenFOAM Meshing & Mesh Conversion | 1 | November 29, 2014 04:54 |
Mesh quality and wall function in FLUENT - k-omega model | newcomer | ANSYS Meshing & Geometry | 1 | May 19, 2011 04:00 |
[ICEM] mesh quality problem in fluent | turbotel | ANSYS Meshing & Geometry | 0 | February 23, 2011 23:24 |