Using case check in fluent for Ansys 15.0

raunakjung · March 14, 2017, 07:46

hello everyone

I read the fluent manual. I found previous fluent versions have check case in solve option to check the grid , the boundary condition and the solver settings.
solve/Case check
This option helps to troubleshoot most of the problems in settings.

I tried to find same in Ansys 15.0 but says " this page is not applicable under current setting " . Is there any command used to implement such in Ansys 15.0

Thank You

pancard · March 14, 2017, 09:56

i use Ansys 17. There is a button of CheckCase on the the top of the panel of Run Calcuation.

March 14, 2017, 07:46	Using case check in fluent for Ansys 15.0	#1
raunakjung Senior Member raunak jung pandey Join Date: Jun 2016 Posts: 102 Rep Power: 9	hello everyone I read the fluent manual. I found previous fluent versions have check case in solve option to check the grid , the boundary condition and the solver settings. solve/Case check This option helps to troubleshoot most of the problems in settings. I tried to find same in Ansys 15.0 but says " this page is not applicable under current setting " . Is there any command used to implement such in Ansys 15.0 Thank You Last edited by raunakjung; March 15, 2017 at 01:00.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Problems converting a Fluent case file	McFly	OpenFOAM Meshing & Mesh Conversion	12	July 21, 2019 21:02
CFX overwhelming Fluent in mass convergence of boundary layer separation case	Pierre1	FLUENT	7	March 26, 2015 21:43
Can't run a case in HelyxOS with an imported mesh from Fluent	HHOS	OpenFOAM Running, Solving & CFD	0	July 2, 2013 06:25
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
Free surface boudary conditions with SOLA-VOF	Fan	Main CFD Forum	10	September 9, 2006 12:24

March 14, 2017, 09:56		#2
pancard New Member Join Date: May 2012 Posts: 5 Rep Power: 13	i use Ansys 17. There is a button of CheckCase on the the top of the panel of Run Calcuation.