|
[Sponsors] |
Sterted Fluent in background mode (without GUI), how to access it again? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: Mar 2017
Posts: 1
Rep Power: 0 ![]() |
Dear all,
i started Fluent in background mode, my simulation is finished but there was a problem while writing the .cas and .dat file. The process is still running at the background. How to communicate with the process and let the it write the results files (under Linux) ? Thanks for your support. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,813
Rep Power: 68 ![]() ![]() ![]() |
I don't think you can.
|
|
![]() |
![]() |
![]() |
Tags |
background, gui, write data |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[PyFoam] Problems with the new PyFoam release | zfaraday | OpenFOAM Community Contributions | 13 | December 9, 2014 18:58 |
access violation in Fluent 6.3 | behest | Fluent UDF and Scheme Programming | 2 | March 24, 2014 09:58 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
PROBLEM in UDF on parallel fluent mode | rakadit | Fluent UDF and Scheme Programming | 0 | July 13, 2012 06:51 |
Run Fluent in batch mode | Shengping LUO | FLUENT | 2 | October 24, 2000 05:42 |