How to add named selections to imported mesh?
Hi all,
I'm new here so I apologise if this is a silly question. I was working with an stl file which I used to create a .msh file in scanIP, and then imported that into Ansys FLUENT. Normally I would create the named selections in the mesh/designmodeller, however since I imported this .msh I could only open the FLUENT component of the workflow. So the question I have is how do I apply the named selections so I can impose boundary conditions (wall, velocity inlet etc.). My geometry is an aortic root and quite complex. Thanks |
All times are GMT -4. The time now is 11:16. |