 |
 |
 |
|
|
|
[Sponsors] | ||||
How to add named selections to imported mesh? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 27, 2017, 19:28
|
How to add named selections to imported mesh?
|
#1 |
|
New Member
PJ
Join Date: Mar 2017
Posts: 7
Rep Power: 10  |
Hi all,
I'm new here so I apologise if this is a silly question. I was working with an stl file which I used to create a .msh file in scanIP, and then imported that into Ansys FLUENT. Normally I would create the named selections in the mesh/designmodeller, however since I imported this .msh I could only open the FLUENT component of the workflow. So the question I have is how do I apply the named selections so I can impose boundary conditions (wall, velocity inlet etc.). My geometry is an aortic root and quite complex. Thanks |
|
|
|
|
|
| Tags |
| beginner, fluent, imported mesh, named selection |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| the mesh file exporter does not support overlapping geometry in named selections | pk176 | Mesh Generation & Pre-Processing | 4 | March 15, 2017 03:47 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
Linear Mode
