[sinemdiscioglu]

hello.
I'm working on nanofluid and modeled the fluent as single phase.
nanofluid convective heat transfer through square cross sectional duct under constant heat flux in laminar flow.

But my results are wrong.I do not know where I made mistakes.I am going to graduate depends on it and have a very very short time.
Can I check my fluent files if you send them to me and Could you say my mistake.

contact:

sinemd11@hotmail.com
+90 545 556 98 95

[ayoub1989]

Originally Posted by sinemdiscioglu

hello.
I'm working on nanofluid and modeled the fluent as single phase.
nanofluid convective heat transfer through square cross sectional duct under constant heat flux in laminar flow.

But my results are wrong.I do not know where I made mistakes.I am going to graduate depends on it and have a very very short time.
Can I check my fluent files if you send them to me and Could you say my mistake.

contact:

sinemd11@hotmail.com
+90 545 556 98 95

hello ,
1-before comparing your results with experimental data, try a verification of your grid with water.
2- check your boundery conditions and select the appropriate one for your case.