 |
 |
 |
|
|
|
[Sponsors] | ||||
May 5, 2017, 16:25
|
Impedance boundary conditions
|
#1 |
|
New Member
Nitesh Kumar
Join Date: Nov 2015
Posts: 5
Rep Power: 11  |
How to apply impedance boundary condition in fluent while simulating carotid artery blood flow?
I am simulating blood flow in carotid artery. I need to apply impedance boundary condition at the outlet of internal and external carotid artery as mentioned in many literatures. can anyone help me apply this Bc in fluent. |
|
|
|
|
|
May 6, 2017, 18:28
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,836
Rep Power: 68 |
The impedance BC should be there if you are in transient mode. I'm not sure if there is a limitation for certain models. But in the GUI it's on the same momentum tab where you specify the mass flow rate, pressure, velocity, etc.
|
|
|
|
|
|
|
February 4, 2018, 14:52
|
Impedence boundary condition in CFX
|
#3 |
|
New Member
Nitesh Kumar
Join Date: Nov 2015
Posts: 5
Rep Power: 11 |
Hi,
how to apply impedance boundary condition in cfx to simulate arterial flow? |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 08:30 |
| Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 09:44 |
| GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 10:49 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Linear Mode
