 |
 |
 |
|
|
|
[Sponsors] | ||||
January 29, 2022, 10:34
|
Modelling Rocket Motor Injector
|
#1 |
|
New Member
Join Date: Jul 2021
Posts: 9
Rep Power: 4  |
Does anyone know how to go about setting up a rocket motor injector in Fluent (i.e. what models and initial conditions are necessary) to be able to effectively find pressure drop across the injector.
|
|
|
|
|
|
February 2, 2022, 20:53
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
you need pressure in tank or mass flow rate of fuel
make a good mesh go on with any turbulent model (k-w is preferable / my opinion)
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low-Re Modelling | doerschlott | OpenFOAM Running, Solving & CFD | 4 | June 23, 2022 06:53 |
| CFD simulation of Rocket nozzle flow separation (Turbulence modelling issue) | balkrishan | Main CFD Forum | 2 | January 2, 2018 06:40 |
| CFD in Naval Hydrodynamics, Off-Shore and Wave Modelling with OpenFOAM | hjasak | OpenFOAM Announcements from Other Sources | 2 | February 13, 2017 04:59 |
| Need help with a rocket nozzle simulation | badboyz31 | CFX | 14 | September 22, 2014 00:06 |
| Rocket Motor Modelling | Anton G. Ishmurzin | Main CFD Forum | 4 | May 6, 2001 06:24 |
Linear Mode
