 |
 |
 |
|
|
|
[Sponsors] | ||||
May 19, 2017, 12:02
|
Export mesh to fluent problem
|
#1 |
|
New Member
Alex Atamari
Join Date: May 2017
Posts: 1
Rep Power: 0  |
I'm trying to follow a tutorial for simulation of cyclone, I did the mesh but when i try to import the mesh from fluent there miss a message:
". . . . preparing mesh for display.... Done " which could be the problem? For doing the mesh i used ICENT CFD 16.0 and 17.1 At the beginning i though it would be due to the version but it is not. Help me |
|
|
|
|
|
May 21, 2017, 16:16
|
What is the problem?
|
#2 |
|
Member
Join Date: Jul 2013
Posts: 99
Rep Power: 13 |
What is the problem exactly?? According to your picture, fluent loaded the mesh properly...
|
|
|
|
|
|
 |
| Tags |
| ansys, fluent, import, mesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
| icem 2 fluent mesh export edges association problem | zdunol | ANSYS | 0 | October 4, 2014 16:04 |
| [ICEM] Problems with export 2D mesh from ICEM to FLUENT | newcomer | ANSYS Meshing & Geometry | 54 | September 20, 2014 12:40 |
| Unable to install OpenFOAM 1.6-ext | Maimouna | OpenFOAM Installation | 23 | May 8, 2014 05:47 |
| [ICEM] 2D mesh export to FLUENT | Ed Kay | ANSYS Meshing & Geometry | 0 | October 22, 2009 11:08 |
Linear Mode
