|
[Sponsors] |
June 19, 2017, 15:40 |
Mesh connection option not showing
|
#1 |
New Member
Gabriel
Join Date: May 2017
Posts: 2
Rep Power: 0 |
Hi, I'm doing a simulation of a 3d centrifugal pump, I created the geometry of the impeller and the volute as one on solidworks, after, on the design modeler, I used boolean to separate them so i could make one stationary and the other rotating.
But when I'm doing the mesh, the option of doing the mesh connection isn't there. I already used it when doing a 2d version of the same problem, but it's not showing it now, and just a interface it's not working. Can somebody help me? If needed i can post the file |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Simple piston movement in cylinder- fluid models | arun1994 | CFX | 4 | July 8, 2016 02:54 |
Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |