|
[Sponsors] |
July 4, 2017, 17:57 |
mass flow outlet
|
#1 |
New Member
ragab ando
Join Date: Nov 2016
Posts: 3
Rep Power: 9 |
Hello fiends
Iam trying to simulate a two phase flow to Describing Cavitation in a Centrifugal Pump and I cant find the mass flow outlet How I can activate the mass flow outlet ? when i tried it with a single phase I was activated it from pressure outlet but when i tried it on two phase flow it is not available any more Is there is any other way to activate it Last edited by ragab; July 6, 2017 at 14:10. |
|
July 4, 2017, 18:12 |
|
#2 |
New Member
ragab ando
Join Date: Nov 2016
Posts: 3
Rep Power: 9 |
https://www.youtube.com/watch?v=9E3Q-cqhkVw&t=59s
like this video |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
Define mass flow profile with regards to species mass fraction | danS | Fluent UDF and Scheme Programming | 0 | June 20, 2017 06:21 |
Mass flow rate boundary condition with negative values | ashtonJ | CFX | 3 | November 26, 2014 05:21 |
mass flow | Wenbin Song | FLUENT | 0 | September 27, 2005 13:00 |
Mass Flow Inlet | Pravir Kumar Rai | FLUENT | 0 | February 19, 2003 14:03 |