CFD Online Discussion Forums - How to pre-Fill a body with water before starting the calculation

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)

- FLUENT (https://www.cfd-online.com/Forums/fluent/)

- - How to pre-Fill a body with water before starting the calculation (https://www.cfd-online.com/Forums/fluent/192370-how-pre-fill-body-water-before-starting-calculation.html)

Peyman-Afshari

September 2, 2017 05:20

How to pre-Fill a body with water before starting the calculation

Hi, I'm trying to fill a single-phased body with water before starting the calculation using ANSYS FLUENT 18.
is there any way to achieve this setup?

CeesH

September 2, 2017 08:06

Set your material properties to water and initialize, make sure water is selected under "cell zone conditions", and initialize.

All times are GMT -4. The time now is 05:45.