|
[Sponsors] |
September 6, 2017, 08:16 |
Pressure drag
|
#1 |
New Member
Join Date: Nov 2013
Posts: 2
Rep Power: 0 |
Hi all,
I ran two cases of same mesh for two different outer boundary condition. 1. Farfield 2. Wall The pressure drag I obtained is very confusing. Case 1 ~10N Case 2 ~ 1N Outer domain dimensions Top, bottom, side - 5L Front - 4L Rear - 6L Velocity - 40m/s Can't interpret anything out of this. Sent from my A0001 using CFD Online Forum mobile app |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 13:23 |
Periodic flow using Cyclic - comparison with Fluent | nusivares | OpenFOAM Running, Solving & CFD | 30 | December 12, 2017 06:35 |
Pressure Outlet Guage pressure | Mohsin | FLUENT | 36 | April 29, 2016 18:16 |
Negative Pressure Drag Coefficient of main airfoil in Multi-Element rear wing | Masoud.A1 | FLUENT | 4 | April 9, 2015 00:17 |
Pressure Drag not calculated correctly in CFX-Post | Andy | CFX | 5 | August 2, 2006 13:06 |