|
[Sponsors] |
November 3, 2017, 11:28 |
3d burner section problem
|
#1 |
New Member
Akram
Join Date: Oct 2016
Posts: 22
Rep Power: 9 |
Hi all,
I am modeling combustion in 3D cylinder flow, I designed only a section of 30 degrees. I put the total value of mass flow rate in inlet boundary condition, and fluent is not considering that this value is for the whole cylinder but as the mass flow rate in the section. Can anyone help with this? Last edited by Aero_Tn; November 4, 2017 at 10:37. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluent Parallelization Problem After AC Power Dropped | pawl | Hardware | 5 | November 13, 2016 06:08 |
Heat Transfert, mixing problem | Wazdq | CFX | 8 | November 7, 2016 05:44 |
Burner flame position problem in CFX | bharath | CFX | 4 | March 27, 2011 09:59 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |