Home > Forums > Software User Forums > ANSYS > FLUENT

overlap rotational interface

Mark Forums Read

Reply

Search this Thread

November 30, 2017, 23:47	overlap rotational interface	#1
aero6760 New Member aero cheng Join Date: Nov 2017 Posts: 1 Rep Power: 0	im building a simulation of CH47. However, after i create the interface for two rotor, there is a overlap volume. Is it any problem in mushing and calculation? Is there any special setup for this case?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 08:30
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 06:15
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 07:28
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 08:00

All times are GMT -4. The time now is 09:08.