 |
 |
 |
|
|
|
[Sponsors] | ||||
Specifying output parameter as Maximum temperature |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 24, 2018, 13:49
|
Specifying output parameter as Maximum temperature
|
#1 |
|
New Member
Adebayo
Join Date: Jan 2018
Posts: 1
Rep Power: 0  |
Good day everyone.
I am studying flow in a pipe and i need to calculate the peak temperature hotspots in the geometry. I mean, i want my output parameter to be maximum temperature so i can monitor the temperature hotspots. Thanks. |
|
|
|
|
|
January 25, 2018, 16:36
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,845
Rep Power: 68 |
Create a volume monitor. Choose the cell zone. Set it to maximum temperature. And so on....
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to get and output temperature at a certain point by using UDF? | aestas | Fluent UDF and Scheme Programming | 7 | October 29, 2018 15:45 |
| where can i find "epsilon" or "" parameter in output? | EBehnamtalab | FLOW-3D | 1 | January 11, 2018 14:35 |
| set output parameter temperature for heat flux | mrtzmoosavian | CFX | 0 | October 11, 2017 20:48 |
| calculating output parameter in cfd post | markus67 | CFX | 3 | August 26, 2015 10:28 |
| Too high maximum gas temperature | Ossi | Siemens | 4 | October 11, 2001 06:13 |
Linear Mode
