[alvinthum]

Hello all, I have a curious, normally the size of particle will influence the Ansys to track it when using dpm injection?

For example, 100μm is more difficult than 2μm when ansys want to track it. This is because when i do the simulation with 2μm always show higher number incomplete particles compare to 100μm. But the thesis i refer is mention that 100μm will have higher incomplete particles. The particle i used is CaC03 and i set it as inert particle. By using group injection and i injet it from inlet and flow with water liquid(both water liquid and CaC03 also flow in 1.5m/s).

Appreciate to those read and reply me.
Result.png