 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2018, 15:44
|
Adapting VOF to heat pipe
|
#1 |
|
New Member
Jack Ha
Join Date: Feb 2018
Posts: 1
Rep Power: 0  |
I am simulating a heat pipe but I want to adapt VOF method for phase change. Because the conventional heat pipe has two flows(water at the wall and vapor at the center), is there a feature that I can choose two flows in a single pipe in Fluent?
Typically, inlets and outlets are where fluid travels but the heat pipe is completely closed. How can I set up inlet and outlet properly? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| a possible substitution of heat exchanger module in fluent?! | Sadegh.A | FLUENT | 0 | September 25, 2017 15:49 |
| Double pipe heat exchanger | mohcin | FLUENT | 21 | June 18, 2016 14:19 |
| Double pipe heat exchanger with SST k-w turbulence model | MStudent | FLUENT | 1 | May 21, 2016 02:31 |
| Heat loss from a steam pipe in windy air | Kontestator | FLUENT | 5 | October 28, 2015 21:24 |
| ANSYS 16.1 Workbench - Cooling Heat Source through Pipe | Ninhalem | ANSYS | 1 | July 26, 2015 19:05 |
Linear Mode
