 |
 |
 |
|
|
|
[Sponsors] | ||||
Extra edges or curves appearing while displaying Mesh on a created 'Plane' |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 25, 2018, 09:36
|
Extra edges or curves appearing while displaying Mesh on a created 'Plane'
|
#1 |
|
Senior Member
vidyadhar
Join Date: Jul 2016
Posts: 138
Rep Power: 11  |
Hello All,
I have created a 3D mesh using Ansys Workbench and running simulations in Fluent after converting into Polyhedra. In Fluent, I have created a 'Plane' and tried to display it. It is appearing with extra edges as shown in the attached file. While displaying Mesh, I have checked only 'Edges' & 'Outline' under EdgeType. I expect only a rectangle to be displayed. I request any one to let me know how to remove these extra lines appearing within the rectangle. Thanks in advance! |
|
|
|
|
|
April 25, 2018, 09:38
|
|
#2 | |
|
Senior Member
Kushal Puri
Join Date: Nov 2013
Posts: 182
Rep Power: 14 |
Quote:
|
||
|
|
|
||
|
April 25, 2018, 10:19
|
|
#3 |
|
Senior Member
vidyadhar
Join Date: Jul 2016
Posts: 138
Rep Power: 11 |
Thanks a lot Kushal!
When I display using Serial mode, the problem is solved. Regards, vidyadhar |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 10:12 |
| [snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 09:26 |
| [ICEM] Checking the mesh -> problem of single edges | Clecl | ANSYS Meshing & Geometry | 21 | September 24, 2012 05:04 |
| ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 17:29 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
