Home > Forums > Software User Forums > ANSYS > FLUENT

modeling entering two phase flow in open channel flow

Updated Threads

Reply

Search this Thread

May 2, 2018, 10:13	modeling entering two phase flow in open channel flow	#1
hesamabtahi New Member Join Date: May 2018 Posts: 1 Rep Power: 0	hi guys, I'm trying to model the open channel flow which two phase flow (air and water) enter the channel and only water exhaust from the channel. actually there is a tunnel that transfer water and air into the open channel flow which water filled the 0.75 percent of capacity of tunnel and the rest of it is filled by air. the total amount of input water discharge with other pipes. can i model it with fluent? if so what kind of boundary i should use for this issue? thanks a lot, hesam abtahi

Reply

Tags

fluent, open flow channel, two phase flow

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Phase selection problem in open channel flow	shoumo_30	FLUENT	1	December 1, 2011 02:48
Open Channel Flow	forsumit	FLUENT	0	October 1, 2009 02:01
open channel flow	sachin jadhav	FLUENT	0	April 9, 2008 15:53
open channel flow boundary conditions	yan	FLUENT	0	July 4, 2005 23:36
compressible two phase flow in CFX4.4	youngan	CFX	0	July 1, 2003 23:32

All times are GMT -4. The time now is 20:58.