|
[Sponsors] |
September 12, 2018, 12:01 |
Reference Values
|
#1 |
Member
Join Date: Dec 2016
Posts: 44
Rep Power: 9 |
How can set a parameter for the reference values in a parametric case?
Otherwise, the calculated cd value is only correct in first design point, because of a different velocity between reference and velocity inlet. |
|
February 21, 2019, 06:47 |
|
#2 |
New Member
Alex
Join Date: Feb 2019
Posts: 4
Rep Power: 7 |
This is the same problem I am having. Have you found a solution?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wmake problems during custom utility compilation | palazi88 | OpenFOAM Programming & Development | 11 | August 13, 2018 20:52 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
It would be wonderful if a tool for FoamToTecplot is available | luckyluke | OpenFOAM Post-Processing | 165 | November 27, 2012 06:54 |
OpenFOAM-2.1.x on fedora 16 x86_64 | anand_30 | OpenFOAM Installation | 3 | December 26, 2011 02:09 |
G95 + CGNS | Bruno | Main CFD Forum | 1 | January 30, 2007 00:34 |