 |
 |
 |
|
|
|
[Sponsors] | ||||
October 12, 2018, 08:56
|
Solid Body in Fluent Meshing Mode
|
#1 |
|
Member
yanki cob
Join Date: Jan 2018
Posts: 30
Rep Power: 9  |
Hi,
I'm new to fluent meshing mode, and I'm trying to mesh a model with a solid body in it (basically it's a computer chassis with just a rectangular chip). I can mesh a model with just fluid, but this solids body creates some problems as I don't know how to treat it (it also creates multi-faces). Do you have any suggestions or resources on this? Regards |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to make appear edge/line body (created in design modeler) in the meshing tool | Rockda | ANSYS Meshing & Geometry | 6 | June 9, 2016 00:10 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 11:49 |
| [ICEM] Meshing Multi Solid Body for CFD | marauder | ANSYS Meshing & Geometry | 0 | March 18, 2015 07:32 |
| Fluent meshing | ferroburak | FLUENT | 2 | October 28, 2014 01:50 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
