 |
 |
 |
|
|
|
[Sponsors] | ||||
The orthogonal quality of the mesh is getting smaller and smaller |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 25, 2018, 04:14
|
The orthogonal quality of the mesh is getting smaller and smaller
|
#1 |
|
New Member
Join Date: Oct 2018
Posts: 1
Rep Power: 0  |
Hello everyone, I am using sliding mesh in FLUENT to simulate the vertical fan. However, as the calculation progresses, the orthogonal mass of the grid becomes smaller and smaller at the partial tip speed ratio. Why is this? I would be very grateful if I can get your reply, thank you.
|
|
|
|
|
|
| Tags |
| orthogonal quality |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
| [ICEM] mesh in-dependency and mesh quality control | sujay | ANSYS Meshing & Geometry | 0 | February 20, 2013 02:06 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
Linear Mode
