|
[Sponsors] |
November 22, 2018, 02:04 |
Ruler cannot be displayed
|
#1 |
Senior Member
Jiri
Join Date: Mar 2014
Posts: 218
Rep Power: 13 |
Hi there,
In Fluent I cannot display the ruler. I came across this issue several times. In display options the ticking square for ruler is grey and it cannot be switched on. On another PC the ruler is visible. Is it related to Windows setup? |
|
December 4, 2018, 04:08 |
|
#2 |
Senior Member
Jiri
Join Date: Mar 2014
Posts: 218
Rep Power: 13 |
No ideas yet? Obviously showing the ruler is a tough issue.
|
|
December 4, 2018, 21:04 |
|
#3 |
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
what is ruler?
make screenshot best regards |
|
December 5, 2018, 02:04 |
|
#4 |
New Member
Stephan Hötzl
Join Date: Dec 2015
Posts: 2
Rep Power: 0 |
The ruler can only be displayed in "Orthographic Projection" mode. Maybe on your PC the projection mode is "Perspective Projection". You can switch between the two modes with the buttons shown in the attached image.
Best regards, Stephan |
|
December 5, 2018, 02:48 |
|
#5 |
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
I don't catch your problem
you may use TUI command to switch view to orthographic Code:
display views camera projection orthographic best regards |
|
January 10, 2019, 10:16 |
|
#6 |
Senior Member
Jiri
Join Date: Mar 2014
Posts: 218
Rep Power: 13 |
Thank you very much :-D
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Cells displayed along Block faces. | McCharles | ParaView | 0 | February 12, 2016 04:06 |
[OpenFOAM] Paraview ruler? | me3840 | ParaView | 2 | February 15, 2015 15:25 |
[General] Representation "Surface" is displayed correctly, but Representation "Outline" is not | macfly | ParaView | 4 | March 22, 2014 09:54 |
wrong colors displayed in ansys Post | Kneck | ANSYS | 0 | September 7, 2013 07:47 |
Contours are not displayed!!!! | viky | FLUENT | 2 | July 18, 2012 05:19 |