2D simulation in Fluent 16.0

ujjwalmohanty · November 25, 2018, 10:26

While performing a 2D simulation in Fluent 16.0, I am getting the following message:
"Update second order grid even though solver is detecting no motion for current time step"

What does it mean and how does it affect my solution?

busraeren · November 26, 2018, 03:48

Can you be more spesific about your case? For example is there any dynamic mesh or moving reference frames?

ujjwalmohanty · November 26, 2018, 09:54

Quote:

Originally Posted by busraeren

Can you be more spesific about your case? For example is there any dynamic mesh or moving reference frames?

Hi,

No there is no dynamic mesh.

Its a simple 2D simulation problem for unsteady flow over a triangle in a fluid domain. The inlet temperature is set at 300 K and the triangle surface is set to 303 K. The top and bottom walls have free slip condition and the outlet is pressure outlet. The inlet velocity is 50m/s, density and viscosity of fluid is set to 1.

LuckyTran · November 26, 2018, 11:58

My guess was also something related to a dynamic mesh. I have no clue why you would see this message if not. Or maybe you are doing automated grid refinement?

ujjwalmohanty · November 26, 2018, 12:04

Guys....I am so sorry...I did use dynamic meshing....my bad that I totally forgot about it...the simulation was running for over a day....

But is the message something that I should be worried about?

November 25, 2018, 10:26	2D simulation in Fluent 16.0	#1
ujjwalmohanty New Member Ujjwal Mohanty Join Date: Mar 2018 Posts: 18 Rep Power: 8	While performing a 2D simulation in Fluent 16.0, I am getting the following message: "Update second order grid even though solver is detecting no motion for current time step" What does it mean and how does it affect my solution?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
looking for a smart interface matlab fluent	chary	FLUENT	24	June 18, 2021 09:07
Start new Ansys Fluent Simulation automatically	Malue	Fluent UDF and Scheme Programming	1	October 4, 2017 01:48
Which Multiphase Model Should be selected in Fluent for my below described simulation	oberstar	Fluent Multiphase	0	September 28, 2017 12:05
Flux reports for transient simulation in Fluent	khaham	FLUENT	11	April 19, 2017 07:44
Simulation on fluent 14	NAD	FLUENT	0	September 11, 2013 02:05

November 26, 2018, 03:48		#2
busraeren New Member Büşra Eren Join Date: Mar 2018 Location: Turkey/Istanbul Posts: 14 Rep Power: 8	Can you be more spesific about your case? For example is there any dynamic mesh or moving reference frames?

November 26, 2018, 11:58		#4
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,672 Rep Power: 65	My guess was also something related to a dynamic mesh. I have no clue why you would see this message if not. Or maybe you are doing automated grid refinement?

November 26, 2018, 12:04		#5
ujjwalmohanty New Member Ujjwal Mohanty Join Date: Mar 2018 Posts: 18 Rep Power: 8	Guys....I am so sorry...I did use dynamic meshing....my bad that I totally forgot about it...the simulation was running for over a day.... But is the message something that I should be worried about?