|
[Sponsors] |
November 29, 2018, 02:54 |
how can set boundry condition
|
#1 |
New Member
MAHDI
Join Date: Nov 2016
Posts: 13
Rep Power: 9 |
i want to simulate a shell and tube steam generator. The boundary conditions given for the pipe at the inlet , which is easily adjustable. In the shell, the boundary conditions are also given, and with temprature and velocity inlet i perform that but The problem is that in the first circuit and second circuit pressure are given in mega-pascal and different values of 7.4 and 15.3, and I do not know how to enter these values . I also send the picture of boundry condition.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICEM Scripting Issues | tylerplowright | ANSYS Meshing & Geometry | 33 | September 27, 2021 16:35 |
How to set h as initial condition | yhaomin2007 | OpenFOAM | 0 | July 7, 2012 00:49 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |