Home > Forums > Software User Forums > ANSYS > FLUENT

monitor of moving wall

Mark Forums Read

Reply

Search this Thread

December 5, 2018, 13:47	monitor of moving wall	#1
masiro New Member jielei Join Date: Dec 2018 Posts: 6 Rep Power: 8	Hello,everyone. I'm simulating the spinning of rotor in the channel(2D). The rotation of rotor, drived by water flow, is passive motion using 6DOF in dynamic mesh. The rotor consists of three blades. I need to monitor the pressure of each blade. What should I do in the Fluent. Thank you!

Reply

Tags

monitor, moving wall

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
Use of moving wall in COMSOL?	MultiPhy	COMSOL	1	September 24, 2018 18:39
partial slip to moving wall	ashokmoravaneni	OpenFOAM	4	March 8, 2018 10:37
Rotating Cylinder (Moving wall vs Moving reference frame vs Sliding mesh)	hamed.majeed	FLUENT	2	January 17, 2017 12:18
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 06:20

All times are GMT -4. The time now is 15:11.