Home > Forums > Software User Forums > ANSYS > FLUENT

Access to interphase exchange

Mark Forums Read

Reply

Search this Thread

February 4, 2019, 06:20	Access to interphase exchange	#1
CeesH Senior Member Cees Haringa Join Date: May 2013 Location: Delft Posts: 607 Rep Power: 0	Hello all, I'm writing a UDF which requires the interphase exchange coefficient as input. Now of course I could manually write out all terms in said UDF, but I hope there is an easier way. Is there any macro to access the interphase exchange coefficient? (I can't find it in the UDF manual..) Best Cees

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[DesignModeler] DesignModeler Scripting: How to get Full Command Access	ANT	ANSYS Meshing & Geometry	54	August 20, 2025 00:15
modelling interphase reaction	cen	STAR-CCM+	3	February 21, 2020 09:08
Interphase mass transfer of a reaction	cfx_ws1992	Main CFD Forum	0	May 15, 2017 22:42
Is there a way to access the gradient limiter in Fluent ?	CFDYourself	FLUENT	1	February 16, 2016 06:49
exchange properties in VOF	mvee	FLUENT	0	October 17, 2007 09:45

All times are GMT -4. The time now is 04:19.