|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Sebastian Pelletier
Join Date: May 2019
Posts: 12
Rep Power: 7 ![]() |
Hello! I currently have a curved surface with a heat transfer distribution. I would like to view an area averaged heat transfer for slices of this surface. Essentially if this was a rectangle I would want to subdivide it into smaller rectangles and calculate the area average heat transfer within those smaller rectangles.
Of course I could break up the surface in Design Modeler and then individually calculate the area weighted average on each new surface but is there a better way to accomplish this within fluent? The end goal is to have a graph of an area weighted average heat transfer ever x mm along the surface thanks in advance for any insights into this! |
|
![]() |
![]() |
![]() |
Tags |
area weighted average, heat transfer coefficeint, impinging jet |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Area weighted or mass weighted average | SAM | Main CFD Forum | 31 | April 30, 2018 05:12 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 16:03 |
average weighted area of volume fraction at output | umar959 | Main CFD Forum | 0 | January 20, 2012 03:47 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
area weighted average | anif hidayatullah | Main CFD Forum | 2 | April 7, 2010 14:47 |