|
[Sponsors] |
August 10, 2019, 12:42 |
Turek-Hron Dynamic mesh
|
#1 |
New Member
omid
Join Date: Jun 2019
Posts: 15
Rep Power: 6 |
Hello
I'm doing FSI modelling of Turek-Hron benchmark, i have set time steps on 0.002 which is proposed by the article, but i still get unusual mesh deformation in some areas, i attache a picture of the mesh, should i make some changes in dynamic mesh set up? if it's true which parameter can effect this? |
|
Tags |
fluent, fsi, mesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
Sliding / Dynamic Mesh in heat transfer problem | platzhalter | FLUENT | 0 | May 7, 2018 05:25 |
[ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 04:19 |
Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 22:09 |
dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 08:03 |