|
[Sponsors] |
Automating using steady state solutions to feed transient |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 28, 2019, 11:31 |
Automating using steady state solutions to feed transient
|
#1 |
New Member
anonymous
Join Date: Aug 2019
Posts: 2
Rep Power: 0 |
Hello,
I am using ANSYS fluent workbench to run a steady state solution to initialize a transient solution. I have successfully done this manually but having trouble automating the process for different parameters in workbench (my parameter is inlet velocity and a changing dt for the transient simulation). I have tried writing a macro within the Calculation Activities and this works for the current design point but when it shuts down Fluent to run the other design points, or I have saved the project then open it again, the macros have disappeared. The ANSYS manual suggests using workbench to link one solution into another but this doesn't seem to work either. Has anyone successfully done this? Are there other ways to go about this? Thank you in advance! |
|
August 29, 2019, 09:28 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,760
Rep Power: 66 |
Have you tried a journal file?
|
|
August 31, 2019, 14:47 |
|
#3 |
New Member
anonymous
Join Date: Aug 2019
Posts: 2
Rep Power: 0 |
Hi LuckyTran, thanks for the reply - I have not tried a journal file, I haven't used this method before. Do you know if these are useful for running multiple parameters through Workbench or do you set up the journal file to run through multiple parameters just using Fluent?
|
|
Tags |
fluent, macros, parameter, transient, workbench |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The difference between steady state and transient | JuPa | CFX | 36 | December 9, 2019 23:50 |
Convergence in steady state simulations vs transient ones | cardioCFD | CFX | 5 | January 21, 2018 11:59 |
Importing solution from thermal steady state analysis to transient analysis | david_1995 | ANSYS | 0 | July 31, 2017 06:54 |
Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 09:56 |
About the difference between steady and unsteady problems | Lisa | Main CFD Forum | 11 | July 5, 2000 15:37 |