|
[Sponsors] |
September 14, 2019, 04:01 |
Failing to start FLUENT
|
#1 |
New Member
Vidushi
Join Date: Sep 2018
Location: Cape Town
Posts: 20
Rep Power: 7 |
Hi all!
I have got a licensed version of Ansys 2019R1 from my university. Design modeler and mesh modeler work fine but when I attempt to open FLUENT, it flashes for a moment without the geometry attached to it and then disappears with an error message saying "FLUENT application failed to start." The operating system that I have is: Processor: i5 8265U CPU @1.60 GHz 1.8GHz Installed Memory: 8.00 Gb System Type: 64 bit Operating System I am using dual boot system with Windows and Linux on the same system by dividing hard drive (512gb) into two parts. The division is as follows: (C: drive): 188gb D: drive - 171gb Linux - 153gb I am attaching the screenshot of the error. Please guide me this issue. |
|
September 14, 2019, 09:53 |
|
#2 |
New Member
Nitesh Dubey
Join Date: Jun 2018
Posts: 4
Rep Power: 7 |
Hi Vidushi,
Wait for sometime when the license is available. Sometimes it happens due to many users accessing the same license. Try after sometime. It happened with me too. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 09:07 |
Start new Ansys Fluent automatically | Malue | Fluent UDF and Scheme Programming | 0 | September 28, 2017 10:53 |
Info message -> Fluent does not start | Jenson | FLUENT | 0 | December 22, 2011 17:21 |
How to start fluent by c++ languang? | xinyijunlinrui | FLUENT | 0 | January 22, 2011 22:43 |
Cannot start fluent with command line | ozzythewise | FLUENT | 2 | October 24, 2010 14:25 |