Zone ID 18 has no nodes
1 Attachment(s)
Afternoon,
I am having issues with mesh coming from Harpoon V6.0 and exporting into Fluent 19.1. There is very little convergence (bordering on divergence), however the real issue is when I try and see any data in TecPlot afterwards. "Zone ID 18 in file "file.cas" has no nodes." I have looked at zone 18 and it is a symmetry plane down the middle of my model. It most certainly has nodes associated with it. I know it isnt useful data that I am trying to find, however this will be very important to my work when I've finally managed to get it to converge. Any help would be massively appreciated, Tait |
Zone ID 44 in file- has no nodes - ERROR in Tecplot
I have a 3D model in ANSYS 2020 R2. I ran it and got my results which were correct. But when I save my analysis as TEC file and try to open it with Tecplot 360 it looks like 2D. Then when I select 3D Cartesian it opens but this time Iso-Surfaces is passive. As far as I understand, the program assumes that my file is 2D.
Then as a second way, I saved the data as .cas and .dat to open the file in Tecplot. However this time in Tecplot there is another error message for me 'Zone ID 44 in file "file.cas" has no nodes.' Please help me if you solved this problem? Thanks |
Zone ID 44 in file- has no nodes - SAME PROBLEM
Quote:
I have a 3D model in ANSYS 2020 R2. I ran it and got my results which were correct. But when I save my analysis as TEC file and try to open it with Tecplot 360 it looks like 2D. Then when I select 3D Cartesian it opens but this time Iso-Surfaces is passive. As far as I understand, the program assumes that my file is 2D. Then as a second way, I saved the data as .cas and .dat to open the file in Tecplot. However this time in Tecplot there is another error message for me 'Zone ID 44 in file "file.cas" has no nodes.' Please help me if you solved this problem? Thanks |
All times are GMT -4. The time now is 23:23. |