 |
 |
 |
|
|
|
[Sponsors] | ||||
July 2, 2020, 07:56
|
Result Visualisation
|
#1 |
|
Member
Join Date: Oct 2019
Posts: 35
Rep Power: 6  |
Hey guys,
Hope you are all well. Is it possible to extract random XY points from an XY plane and their corresponding state variables? I am trying to plot such a 3D graph of X and Y points against the corresponding simulated temperature along an XY plane. The 3D graph below was plotted using measured temperature values at the corresponding XY locations. Thanks so much. Much appreciated |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how use the result data as initial data | n4a0505 | OpenFOAM Post-Processing | 1 | March 4, 2015 02:01 |
| how to make analysis from the result in fluid flow (CFX) ansys workbench 14 | wan11 | CFX | 3 | December 18, 2014 19:25 |
| Result output chart | YaX | CFX | 4 | July 10, 2014 18:47 |
| bad result output | junarzt | OpenFOAM Running, Solving & CFD | 0 | March 19, 2014 10:40 |
| Comparison the airfoil 0012 experimental result and simulation result | harrislcy | FLUENT | 30 | August 29, 2013 10:27 |
Linear Mode
