Multibody Control Volume - Flow Problem

Guvennergiz · July 16, 2020, 13:03

Hello Dear CFD Lovers,
First of all, i am new in forum so please inform me if i am doing something wrong while posting.

Recently i am working on a 3D hex control volumes which has multi bodies. But i formed a new part and they are all in a same zone. Normally there shouldnt be a problem but in Fluent the flow is stacking at the 1st section. All bodies are fluid (air).

It would be nice if you can help me (or inform me if this problem posted-solved before).

Thank you.
Best regards,
Güven

P.s: Yes that is coarsed mesh, i've just wanted to see if the flow can pass through.

baccus · July 17, 2020, 06:10

I have same problem also. Flow stucks in the body and doesn't go through the body.

I guess that it is not about interfaces. Any reasons for these type of problems ??

Guvennergiz · July 21, 2020, 09:26

Help please, thank you.

July 17, 2020, 06:10		#2
baccus New Member Mert Join Date: Aug 2016 Location: Turkey Posts: 12 Rep Power: 9	I have same problem also. Flow stucks in the body and doesn't go through the body. I guess that it is not about interfaces. Any reasons for these type of problems ?? Guvennergiz likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Problem with porous flow at multi-material interface with large permeability diff.	Hisham	OpenFOAM Programming & Development	1	June 3, 2016 10:51
multiphaseEulerFoam (OF2.3.0) : Courant number explodes when running in parallel	Mehrez	OpenFOAM Running, Solving & CFD	10	May 18, 2016 11:44
Problem with an old Simulation	FrankW	CFX	3	February 8, 2016 04:28
Volume flow rate boundary condition in OpenFOAM	mayank.dce2k7	OpenFOAM Running, Solving & CFD	13	August 11, 2014 20:16

July 21, 2020, 09:26		#3
Guvennergiz Member Guven Nergiz Join Date: Jul 2020 Location: Turkey Posts: 52 Rep Power: 5	Help please, thank you.