Home > Forums > Software User Forums > ANSYS > FLUENT

Fully developed temperature profile at tube inlet

Mark Forums Read

Reply

Search this Thread

September 1, 2020, 06:11	Fully developed temperature profile at tube inlet	#1
amrkaood New Member amr kaood Join Date: Nov 2013 Posts: 4 Rep Power: 14	Dears, I need to make a fully developed temperature profile boundary condition at tube inlet. A constant heat flux boundary condition on the tube wall. Can you help by the expression.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Defining 2D Temperature Profile for two inlet patches	afzaal	Fidelity CFD	0	April 12, 2017 01:48
Patch fully developed velocity and turbulence profile over full domain	Teumde	FLUENT	2	June 29, 2015 14:47
Couple outlet to inlet to achieve a fully developed flow.	raghu.tejaswi	Fluent UDF and Scheme Programming	8	July 18, 2013 10:04
Fully developed temperature profile in OF !!!	Goutam	OpenFOAM Running, Solving & CFD	0	July 5, 2012 08:44
translational periodic BC vs Fully Developed Profile at Inlet	Prakash.Paudel	FLUENT	1	August 20, 2010 12:01

All times are GMT -4. The time now is 12:50.