Interpolating Solution Onto New Mesh.

epaj95 · September 28, 2020, 06:55

Hello all.
I have a simulation (single inlet/outlet tube) which I run on a fine mesh. After the solution has converged, I want to interpolate these results onto a mesh with different nodes. I've seen this video which does something similar: https://www.youtube.com/watch?v=Wo59YAj-Ngk

My only issue is that this method requires you to run calculations afterwards to reach convergence on the new mesh... I don't want to continue the solution I just want to interpolate my values. The reason is my other mesh is built in a structured way, which will allow me to order the results how I want (but this mesh is not suitable for CFD).

So essentially I would like to run CFD on very fine mesh -> interpolate results onto a coarse (but ordered mesh) with nodes I have basically manually selected.

I hope this idea makes sense and I have not made a silly judgement of error. Any ideas are very welcome.

hnemati · October 5, 2020, 03:47

Hello,
Normally, what I do is other way around. Run on coarse and interpolate for fine mesh. I am afraid, this is how it works, after interpolation you should run the simulation to adapt the flow with the new mesh. However, it much shorter that starting the simulation from random initial conditions.

September 28, 2020, 06:55	Interpolating Solution Onto New Mesh.	#1
epaj95 New Member PJ Join Date: Mar 2017 Posts: 7 Rep Power: 9	Hello all. I have a simulation (single inlet/outlet tube) which I run on a fine mesh. After the solution has converged, I want to interpolate these results onto a mesh with different nodes. I've seen this video which does something similar: https://www.youtube.com/watch?v=Wo59YAj-Ngk My only issue is that this method requires you to run calculations afterwards to reach convergence on the new mesh... I don't want to continue the solution I just want to interpolate my values. The reason is my other mesh is built in a structured way, which will allow me to order the results how I want (but this mesh is not suitable for CFD). So essentially I would like to run CFD on very fine mesh -> interpolate results onto a coarse (but ordered mesh) with nodes I have basically manually selected. I hope this idea makes sense and I have not made a silly judgement of error. Any ideas are very welcome.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Convergence	Centurion2011	FLUENT	48	June 14, 2022 23:29
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
periodic straight tube flow, no mesh independent solution for pressure gradient	thijs1909	FLUENT	5	May 16, 2018 09:04
Naca 0012 (compressible and inviscid) flow convergence problem	bipulsaha	FLUENT	1	July 6, 2011 07:51
Mesh	Mignard	FLUENT	2	March 22, 2000 05:12

October 5, 2020, 03:47		#2
hnemati Member SAM Join Date: Apr 2012 Posts: 74 Rep Power: 13	Hello, Normally, what I do is other way around. Run on coarse and interpolate for fine mesh. I am afraid, this is how it works, after interpolation you should run the simulation to adapt the flow with the new mesh. However, it much shorter that starting the simulation from random initial conditions.