[eng_shd]

hello everyone
I am doing a two-way fsi simulation using ansys fluent and mechanical apdl.
my problem is 2.5d airfoil and transient analysis used. the leading edge , lower part of middle of airfoil and small part of trailing edge are fixed and between them there is a flexible membrane. i set zero displacement in z coordinate for both symmetry plane of my geometry in structural and then define fluid solid interface. my problem is 2.5d and have only one element in z direction. i used remeshing and smoothing for dynamic mesh and set this setting for fluid:
symmetry 1 and 2 > deforming
membrane > system coupling
rigid part (leading edge and trailing edge that fixed) > stationary
the system coupling run successfully but i cant see any deformation in membrane, i changed the membrane properties but the problem still exist.
Any idea about where the problem could be? If more info is needed, just ask.

Thank you!

[eng_shd]

help me please