|
[Sponsors] |
December 1, 2020, 11:19 |
Modeling Wheel Rotation using MRF
|
#1 |
New Member
Łukasz Borys
Join Date: Dec 2020
Posts: 3
Rep Power: 6 |
Hi. My name is Lukas. I compare the methods of modeling the wheel motion in the CFD analyzes of the Formula Student car in ANSYS FLUENT. I'm having trouble using the MRF approach. I get this message and I don't know if my settings are correct. Review wall motion. Stationary wall motion relative to adjacent cell zone detected.
I have two cell zones.One of them is stationary. Second one is MRF zone which is rotating: 72 rad/s, absolute. Part of the wheel rim is inside of the MRF zone. The part of the wheel rim inside the MRF zone is defined as: Moving Wall - Relative to Adjacent Cell Zone, 0 rad/s. The only stationary wall in my domain is located in my stationary domain - the black part below. https://imgur.com/a/rxyqijw It is located next to the MRF zone. I don't know what to think about this Warning. I think that my setup is correct, but I'm not sure. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam diverges when MRF rotation is flipped | jgross | OpenFOAM Running, Solving & CFD | 3 | September 13, 2019 04:50 |
Modeling furnace simulation with porous media and MRF at high temperature with FLUENT | J_Pratik | FLUENT | 0 | February 22, 2019 06:41 |
Wind Tunnel Simulation with Rotation Wheel | andr3s_diaz | STAR-CCM+ | 5 | May 6, 2018 08:09 |
UDF for 1DOF Rotation | ram_call | Fluent UDF and Scheme Programming | 5 | December 29, 2017 14:55 |
MRF rotation in unstady simulation | Clementhuon | Siemens | 0 | May 25, 2012 03:45 |