|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Prakhar Yadav
Join Date: Dec 2020
Posts: 8
Rep Power: 6 ![]() |
I am simulating a 2D turbine using 6DoF method in Ansys Fluent.
The goal is to find the moment coefficient of the turbine rotating at certain RPM in an inlet wind speed of 7m/s. I am using a All triangular mesh method with 413k elements, with minimum edge sizing of 0.05mm thus getting Skewness of 0.732. In Ansys Fluent I am trying to simulate turbulent flow using K - Epsilon method and coupled solver. For first case I gave 100 rpm in Mesh motion(turbine is rotating at 100 rpm). The simulation study is supposed to run for 30 secs with time step size of 0.0001 sec. After 100 iterations I get a negative cell volume error, to rectify this I reconfigured my mesh edge sizing from 0.05 to 1.2mm keeping the Time step size to 0.0001sec only. I tried some method's to eliminate this error, Can anyone help me eliminating this error. P.S snips of the fluent solver, mesh b1.jpg b2.jpg b3.jpg b4.jpg b5.jpg |
|
![]() |
![]() |
![]() |
Tags |
ansys fluent, coupled solver, fluent, mesh 2d, turbine blade |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] swak4foam openfoam 7 installation problem | Andrea23 | OpenFOAM Community Contributions | 1 | February 17, 2020 19:11 |
How to use "translation" in solidBodyMotionFunction in OpenFOAM | rupesh_w | OpenFOAM Running, Solving & CFD | 5 | August 16, 2016 05:27 |
Mesquite - Adaptive mesh refinement / coarsening? | philippose | OpenFOAM Running, Solving & CFD | 94 | January 27, 2016 10:40 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |