|
[Sponsors] |
March 19, 2021, 12:42 |
k-omega internal flow simulation
|
#1 |
New Member
Join Date: Jan 2021
Posts: 2
Rep Power: 0 |
Hello
I have a little convergence problem here. I want to do a flow calculation with k-omega sst. All settings are deafault. The energy is still activated because the pipe runs in the component and the component is heated on one side. Now the convergence on this model is very poor. I use uniform boundary layer with Growth Rate 1.05 and First Height 0.03. So that my Y-Plus value remains small. What can I do to improve the convergence? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind Tunnel Flow Simulation Mass Flow BC Issue | ledelman | SU2 | 4 | August 3, 2014 18:38 |
Internal flow simulation BCs | SteveGoat | FLUENT | 0 | May 10, 2012 06:41 |
Differences and functions of Solidworks Simulation and Solidworks Flow Simulation? | alpharays | Main CFD Forum | 0 | April 19, 2012 03:13 |
Internal flow simulation boundary conditions | Kishore | FLUENT | 1 | July 10, 2007 11:42 |
Internal flow simulation | Kishore | FLUENT | 8 | June 6, 2007 12:17 |