|
[Sponsors] |
July 5, 2021, 10:07 |
Parametric Analysis; Design of Experiments
|
#1 |
New Member
Surya S
Join Date: Jun 2021
Posts: 2
Rep Power: 0 |
I would like to know if you can set an input parameter for an imported model (like .stp) while performing parametric analysis and DOE. Also, is it always necessary to set the output parameter from cfd-post, for parametric analysis and doe. Since I seem to get a error while updating the design points if i set the output parameter via fluent directly
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bladegen parametric analysis | Avni | ANSYS | 0 | March 6, 2019 07:38 |
Design and analysis of Hybrid VAWT. | Ajinkya Patil | ANSYS | 2 | December 29, 2016 02:04 |
Fluent parametric analysis with workbench runs solwly | hjxy2012 | FLUENT | 1 | August 27, 2016 23:16 |
Radial turbine design and analysis | Renhick | FLUENT | 1 | December 18, 2012 10:57 |
Cfd analysis for design of tank internals | ashishpvnit | Main CFD Forum | 0 | March 19, 2010 01:44 |